NateChrony SmartTarget
TBA
Follow these steps to be able to test and get familiar with your NateChrony without having to mount it or fire a single shot!
-
Read the safety instructions Safety First
-
Power up your NateChrony with a USB cable and power supply
-
Connect your mobile/tablet/laptop to the Chrony WiFi network
-
Open your browser & access the NateChrony page via one of the below methods:
- http://192.168.4.1
- http://natechrony
- http://natechrony.local
- http://steadyshot
- http://steadyshot.local
- Use your camera with this QR Code:
-
Drop the test pellet through the NateChrony, its important to use the test pellet or something 7mm/30cal to ensure it triggers both sensors
-
It should read approximately 4fps, repeat the drop 2-3 times
-
You should see an alignment error, this is expected
-
If the pellet doesnt pass through quickly (>0.5fps), the chrony may detect a sensor issue & reset - make sure its dropped vertically and doesnt rattle about inside
SmartTarget
Follow these steps to setup and test your SmartTarget
Last Updated: 2025-05-26 09:59:59 +1000 AEST